Paintless dent repair tips

Another way to fix the small dents is parking your car in a sunny area. This is an effective way that most of car enthusiasts all know. By doing this way, the metal will heat up and expand. As the car surface expands, the shallow and light dents will pop out. The longer you park your car in a sunny area, the more likely this way will work.

Restoring your hail damaged vehicle ? If you are considering learning the skill of how to do paintless dent repair, it’s important to understand that it isn’t simply a matter of “popping” a dent out and expecting that the body will be perfect again. PDR involves a very slow and methodical process that requires special tools, a certain level of knowledge and skill, and a great deal of patience. Some dent repairs, even on small dents, can take up to two hours.

First let’s start with some car paint care advices: Fixing Scratches: Apart from rust-proofing the vehicle, you should fix small scratches promptly. If the scratch is not too deep, you should only use touch up paint and finish off with a rubbing compound to get a good shine. If the scratch is deep and exposes the metal, you will have to sand off the surrounding paint and apply primer before painting the affected area.

So, we’ve explained what the procedure looks like — assuming it was done properly. And as you could probably guess there are a lot of ways an amateur or first-timer can get it wrong. It’s different than most other car repairs because it’s not about mechanical prowess; it’s more about control and the ability to maintain a steady hand and a gentle pace. You can’t rush it. The problem is, once a sheet metal repair starts to go awry, you’re usually much, much worse off than if you’d just left it alone. Metal holds its shape, but only to a certain point. Let’s say you get a dent in the hood — nothing too drastic, just a shallow, even dent with no sharp creases in an area that’s pretty easy to reach. You think it’ll be easy to pop it out on your own, so you begin to massage the underside while holding your shaping tool in place. You’ve made good progress so far, and a casual observer wouldn’t even notice the flawed area. But it’s not exactly perfect, and since it’s been fairly easy to this point, you decide to keep massaging the area to make it flawless. After a few more minutes of massaging, you realize that you’ve pushed it just a little too far. And now you’ve got this flabby area on the hood where you stretched out the metal. And there’s no easy way to shrink it back down. Keep going and it’ll stretch even more. Lesson learned. See extra info at Paintless dent repair.